液壓傳動系統，液壓系統加工定做廠家，液壓系統配套設計，小型液壓站
安裝形式： | 按照客戶要求 | 公稱壓力： | 21（MPa） |
加工定制： | 是 | 材質： | 鑄鐵 |
產品別號： | 液壓站 | 型號： | 非標液壓系統設計 |
合用溫度： | 0-65（℃） | 合用范圍： | 液壓機械 |
品牌： | 金中KQK | 合用介質： | 油品 |
電磁閥的控制電壓：交流電磁鐵一般為220V，直流電磁鐵為24V，必需使用控制電壓要與電磁鐵標牌。
1.外接控制線及閥及閥引入控制電壓
外接電氣控制線由電氣盒引入，請?zhí)貏e留意電機轉向要與泵箭頭標的方向。 C左右，再投入運動。（有加熱器的可直接加熱升溫
2.對于帶記憶元件的電磁閥要短時通電。
液壓系統日常維護
3.液壓成套系統用油及工作前提
采用46號、68號液壓油。zui相宜的油溫為30-60℃當油溫低于1℃或大于65℃時禁止開機，為調節油溫可事先采用加熱器或冷卻器。液壓傳動zui忌油液變臟變質，否則塵埃糊粘在吸油濾油器上，噪音加劇，泵壽命降低，故要常常保待油液潔凈，應三個月清洗油網一次。
4.油泵電機的啟動
液壓站的油泵電機啟動與其它機械一樣，要求空載（卸荷）啟動，等短暫動行后，再行加載工作，一般情況下，工作過程中不宜頻繁啟、閉電機。
在低溫啟動時，要調整溢流閥到1/2的額定壓力，再反復點動電機，使溢流閥全溢流，以給液壓加溫，待溫度升高至20。液壓油一般為12個月應更換一次，并清洗油箱，去除污垢塵埃。
主要設計有各噸位液壓機，液壓升降臺，冶金設備液壓系統，制鏈設備液壓系統，汽車尾板用微型液壓系統，港口排水板液壓系統及其他非標液壓系統。提供液壓技術咨詢，液壓系統解決方案等。 公司承接各類非標液壓設備的設計與出產。
公司主要生產液壓油泵、齒輪泵、柱塞泵、液壓系統、液壓泵站設計、等液壓產品。如需定做液壓系統的客戶J本公司可以根據客戶的需求來設計和計算J客戶只需提供一套液壓系統的一些數據和參數就行了。公司己在液壓行業有14年的經驗我們的所有配件都是進口的J質量是有保證和老客戶的見證的。如果7天內質量有問題無條件包退換（人為除外），一年內保修。
GW：www.yeyaxt。。ｃｏｍ www.jzyyz。。ｃｏｍ www.pumps88。。ｃｏｍ
DH：
SJ： 蔣 （業務）
SJ： 周 （銷售員）
Hydraulic transmission , hydraulic system custom processing factory , hydraulic system supporting the design , small hydraulic station
Installation: according to customer requirements Nominal pressure : 21 （MPa）
Custom processing: Material: cast iron
Product Alias ??: Hydraulic Station Model: non-standard hydraulic system design
Combined temperature : 0-65 （℃） combined range: Hydraulic Machinery
Brand: Golden KQK combined medium: oil
Solenoid valve control voltage: AC solenoids typically 220V, DC solenoid is 24V, the control voltage must be used consistent with the electromagnet signs .
1 External control lines and valves and valve into the control voltage
External electrical control lines introduced by the electrical box , please pay special attention to the pump motor rotation direction arrow target . C or so , and then put into motion . （ A heating temperature of the heater can be directly
2 For solenoid valves with memory elements to short- energized.
Routine maintenance of hydraulic systems
3 complete sets of hydraulic system oil and working premise
Recommend the use of 46 , 68 hydraulic oil. The most affordable oil when the oil temperature is 30-60 ℃ lower than 1 ℃ or higher than 65 ℃, prohibiting boot, in order to adjust the oil temperature in advance using the heater or cooler. Hydraulic fluid gets dirty very sensitive to deterioration , or paste sticky dust on the oil filter , noise intensified, pump life is reduced , so the oil should always be clean and insurance , oil should be cleaned three months net once.
4 pump motor start
Hydraulic pumps at service stations and other mechanical motor starters , requires no load （ unloading ） start, and other short-term fixed -line , re -loading to work under normal circumstances, the work process should not be frequent opening and closing of the motor.
Start at low temperatures , to adjust the relief valve to 1/ 2 of the rated pressure , and then repeated to move the motor , so that all the overflow relief valve to the hydraulic heating until the temperature rises to 20. Hydraulic oil is generally 12 months should be replaced once , and clean the fuel tank, remove dirt dust .
Main design of the tonnage hydraulic machine , hydraulic lifts, metallurgical equipment hydraulic systems, hydraulic systems equipment manufacturing chain , car tail boards using a micro- hydraulic systems, hydraulic systems drain port and other non-standard hydraulic system. Provide hydraulic technology consulting, hydraulic system solutions , such as full service . Company to undertake various non-standard design and production of hydraulic equipment .
The company mainly produces hydraulic pumps, gear pumps , piston pumps , hydraulic systems , hydraulic pump station design , and other hydraulic products. For custom hydraulic systems Customer J The company can according to customer needs to design and calculate J customers simply provide a hydraulic system of some data and parameters on the line. Company has been in the hydraulic industry has 14 years of experience in all of our accessories are imported J quality is guaranteed and old customers witness . If quality problems within 7 days unconditionally package returned （ except artificial ） , one year warranty.
GW: www.yeyaxt。。ｃｏｍ www.jzyyz。。ｃｏｍ www.pumps88。。ｃｏｍ
DH :
SJ: Miss Jiang （ Business Manager ）
SJ: Chow （ salesman ）
