If the ultrasonic cleaner is used improperly, it will affect the normal work and cleaning effect. In order to ensure the specific use experience of the ultrasonic cleaning machine, it can be analyzed according to the power density of the ultrasonic cleaning machine, the cleaning time, temperature and other factors of the ultrasonic frequency machine and the specific use experience. The higher the temperature of the cleaning machine, the more conducive to the separation of stains. However, if the temperature reaches a certain range, it will affect the effectiveness of ultrasonic and reduce the cleaning effect of the cleaning machine.

清洗機的清洗時間應根據產品的不同進行設定，另外，除了材料、清洗劑和污漬的種類外，應用高功率密度解決較難的零件，應用低功率密度的零件，頻率汽化程度較低，頻率偏移效用大，對于簡單表面、復雜表面和深孔，在工作中需要用高頻超聲波清洗機產生流場聲，并能輕易將清洗劑加去。

The cleaning time of the cleaning machine should be set according to different products. In addition to the types of materials, cleaning agents and stains, high power density should be used to solve difficult parts, and low power density parts should be used, with low frequency vaporization degree and large frequency offset effect. For simple surfaces, complex surfaces and deep holes, high frequency ultrasonic cleaning machine should be used to generate flow field sound during work, and the cleaning agent can be easily added.

全自動超聲波清洗機工作時，應盡量避免溫度升高，以免影響設備的正常運行，要注意清洗劑的安全，禁止在超聲波清洗機內有其他異常物體迸出，要經常維護和保養超聲波清洗機，由于建議應立即清理干凈槽底異物，更換或倒出清洗液，需要在常溫下進行設備保養和清洗用具。

During the operation of the full-automatic ultrasonic cleaner, the temperature rise should be avoided as far as possible to avoid affecting the normal operation of the equipment. The safety of the cleaning agent should be paid attention to. It is forbidden to have other abnormal objects burst out of the ultrasonic cleaner. The ultrasonic cleaner should be maintained and maintained frequently. It is recommended that the foreign matters at the bottom of the tank should be cleaned immediately, and the cleaning solution should be replaced or poured out. The equipment maintenance and cleaning tools should be carried out at room temperature.

超聲波清洗機正常工作時，應聽到超聲波聲和槽內均勻的響聲，不要攪動清洗液的表面，全自動超聲波清洗線應只在清洗孔內灑水產生，在保證清洗對象整潔的前提下，不要加溫和間歇工作，由于加溫和長時間的超聲波會提高槽內溫度。

When the ultrasonic cleaner works normally, the ultrasonic sound and the uniform sound in the tank should be heard. Do not stir the surface of the cleaning solution. The automatic ultrasonic cleaning line should only be produced by spraying water in the cleaning hole. On the premise of ensuring that the cleaning object is clean, Z should not heat up or work intermittently. The temperature in the tank will be increased due to heating and long-time ultrasonic.