當前位置：上海巨納科技有限公司>>二維材料>>硒化物晶體>>ReSSe crystals 硒化硫錸晶體

ReSSe crystals 硒化硫錸晶體

返回列表頁

參考價

面議

具體成交價以合同協議為準

產品型號

品牌

廠商性質其他

所在地上海

在線詢價 收藏產品查看聯系電話

聯系方式：袁文軍查看聯系方式

更新時間：2024-02-12 14:22:00瀏覽次數：109次

聯系我時，請告知來自環保在線

產品分類 品牌分類

  二維材料

二維材料粉末

二維材料溶液

碲化物晶體

硒化物晶體

硫化物晶體

絕緣體

鈣鈦礦

異質結

MOFS材料

二維材料薄膜

黑磷

六方氮化硼

其他二維材料

全部產品列表

暫無信息

上海巨納科技有限公司

經營模式：其他

商鋪產品：574條

所在地區：

聯系人：袁文軍

詢價 給他留言

產品簡介

簡要描述：Single crystal ReSxSe2（1-x） alloy rystals are developed at our facilities using chemical vapor transport or flux zone technique methods.

詳細介紹

Single crystal ReSxSe2(1-x) alloy rystals are developed at our facilities using chemical vapor transport or flux zone technique methods. Our ReSSe2 crystals display impressive structural anisotropy from bulk down to monolayers as evidenced by TEM and angle resolved Raman spectroscopy measurements (see XRD, TEM, Raman, PL, and other figures below). Crystals are perfectly layered, and ready for exfoliation. Our R&D team also provides you with transfer technique to boost your monolayer yield rate up to 95%. Alloys are 99% guaranteed to anisotropic and homogeneously alloyed (not phase separated).

Typical characteristics of ReSSe2 alloyed crystals from 2Dsemiconductors

、

Growth method matters> Flux zone or CVT growth method? Contamination of halides and point defects in layered crystals are well known cause for their reduced electronic mobility, reduced anisotropic response, poor e-h recombination, low-PL emission, and lower optical absorption. Flux zone technique is a halide free technique used for synthesizing truly semiconductor grade vdW crystals. This method distinguishes itself from chemical vapor transport (CVT) technique in the following regard: CVT is a quick (~2 weeks) growth method but exhibits poor crystalline quality and the defect concentration reaches to 1E11 to 1E12 cm-2 range. In contrast, flux method takes long (~3 months) growth time, but ensures slow crystallization for perfect atomic structuring, and impurity free crystal growth with defect concentration as low as 1E9 - 1E10 cm-2. During check out just state which type of growth process is preferred. Unless otherwise stated, 2Dsemiconductors ships Flux zone crystals as a default choice.