污水處理設備 污泥處理設備 水處理過濾器 軟化水設備/除鹽設備 純凈水設備 消毒設備|加藥設備 供水/儲水/集水/排水/輔助 水處理膜 過濾器濾芯 水處理濾料 水處理劑 水處理填料 其它水處理設備
廣州市瑞東電子科技有限公司
會員1.png)
廣州市瑞東電子科技有限公司
| 參 考 價 | 面議 |
產品型號
品 牌
廠商性質其他
所 在 地廣州市
聯系方式：查看聯系方式
更新時間：2024-11-20 10:27:48瀏覽次數：63次
聯系我時，請告知來自 環保在線暫無信息 |
Features: Up to 155Mb/s Data LinksHot-PluggableDuplex LC connectorUp to 120km on 9/125μm SMF1270nm～1610nm CWDM DFB laser transmitterSingle +3.3V Power Sup......
RSPD-01C120-XX
155Mb/s 120km CWDM SFP Transceiver
Hot Pluggable, Duplex LC, +3.3V, 1270nm～1610nm, CWDM DFB-LD, Single-mode, DDM
Description:
FIBERWDM’s RSPD-01C120-xxTransceiver is a high performance, cost effective module which have a duplex LC optics interface. Standard AC coupled CML for high speed signal and LVTTL control and monitor signals. The receiver section uses a PIN receiver and the transmitter uses a 1270nm～1610nm CWDM DFB laser, up to 29dB link budge ensure this moduleSONETOC-3/SDHSTM-1 120km application.
Absolute Maximum Ratings
| Parameter | Symbol | Min. | Typical | Max. | Unit |
| Storage Temperature | TS | -40 |
| +85 | °C |
| Supply Voltage | VCC | -0.5 |
| 4 | V |
| Relative Humidity | RH | 0 |
| 85 | % |
Recommended Operating Environment
| Parameter | Symbol | Min. | Typical | Max. | Unit | |
| Case operating Temperature | Industrial | TC | -40 |
| 85 | °C |
| Extended | -5 |
| 85 | °C | ||
| Commercial | 0 |
| +70 | °C | ||
| Supply Voltage | VCC | 3.135 |
| 3.465 | V | |
| Supply Current | Icc |
|
| 300 | mA | |
| Inrush Current | Isurge |
|
| Icc+30 | mA | |
| Maximum Power | Pmax |
|
| 1 | W | |
Electrical Characteristics(TOP =-40 to85°C, VCC = 3.135 to 3.465 Volts)
| Parameter | Symbol | Min. | Typical | Max. | Unit | Note |
| Transmitter Section: |
| |||||
| Input differential impedance | Rin | 90 | 100 | 110 | W | 1 |
| Single ended data input swing | Vin PP | 250 |
| 1200 | mVp-p |
|
| Transmit Disable Voltage | VD | Vcc – 1.3 |
| Vcc | V | 2 |
| Transmit Enable Voltage | VEN | Vee |
| Vee+ 0.8 | V |
|
| Transmit Disable Assert Time | Tdessert |
|
| 10 | us |
|
| Receiver Section: |
| |||||
| Single ended data output swing | Vout,pp | 300 |
| 800 | mv | 3 |
| Data output rise time | tr |
|
| 500 | ps | 4 |
| Data output fall time | tf |
|
| 500 | ps | 4 |
| LOS Fault | Vlosfault | Vcc – 0.5 |
| VCC_host | V | 5 |
| LOS Normal | Vlos norm | Vee |
| Vee+0.5 | V | 5 |
| Power Supply Rejection | PSR | 100 |
|
| mVpp | 6 |
Note:
1. AC coupled.
2. Or open circuit.
3. Into 100 ohm differential termination.
4. 20 – 80 %
5. LOS is LVTTL. Logic 0 indicates normal operation; logic 1 indicates no signal detected.
6. All transceiver specifications are compliant with a power supply sinusoidal modulation of 20 Hz to 1.5MHz up to specified value applied through the power supply filtering network shown on page 23 of the Small Form-factor Pluggable (CWDM SFP) Transceiver Multi-Source Agreement (MSA), September 14, 2000.
Optical Parameters (TOP =-40 to85°C, VCC = 3.135 to 3.465 Volts)
| Parameter | Symbol | Min. | Typical | Max. | Unit | Note |
| Transmitter Section: | ||||||
| Center Wavelength | λc | λ-6 | λ | λ+7.5 | nm |
|
| Spectral Width | σ |
|
| 1 | nm |
|
| Optical Output Power | Pout | 0 |
| 5 | dBm | 1 |
| Optical Rise/Fall Time | tr / tf |
|
| 500 | ps | 2 |
| Extinction Ratio | ER | 10 |
|
| dB |
|
| Generated Jitter (peak to peak) | JTXp-p |
|
| 0.07 | UI | 3 |
| Generated Jitter (rms) | JTXrms |
|
| 0.07 | UI | 3 |
| Eye Mask for Optical Output | Compliant with G.957(class 1 laser safety) |
| ||||
| Receiver Section: |
| |||||
| Optical Input Wavelength | λc | 1260 |
| 1620 | nm |
|
| Receiver Overload | Pol | -8 |
|
| dBm | 4 |
| RX Sensitivity | Sen |
|
| -34 | dBm | 4 |
| RX_LOS Assert | LOS A | -47 |
|
| dBm |
|
| RX_LOS De-assert | LOS D |
|
| -37 | dBm |
|
| RX_LOS Hysteresis | LOSH | 0.5 |
|
| dB |
|
| General Specifications: | ||||||
| Data Rate | BR |
| 155 |
| Mb/s |
|
| Bit Error Rate | BER |
|
| 10-12 |
|
|
| Max. Supported Link Length on9/125μmSMF@155Mb/s | LMAX |
| 80 |
| km |
|
| Total System Budget | LB | 29 |
|
| dB |
|
Note
1. The optical power is launched intoSMF.
2. 20-80%.
3. Jitter measurements taken using Agilent OMNIBERT 718 in accordance with GR-253.
4. Measured with PRBS 27-1 at 10-12 BER
Mechanical Dimensions
Mechanical Drawing
Order Information:
In the Part No. ofRSPD-01C120-xx,xx stands for central wavelength, such as:
27: for 1270nm, 29: for 1290nm, 31: for 1310nm,……61: for 1610nm.
您感興趣的產品PRODUCTS YOU ARE INTERESTED IN
環保在線 設計制作，未經允許翻錄必究 .? ? ?
請輸入賬號
請輸入密碼
請輸驗證碼
